AVS Carflector Installation Instructions - Page 2

Print Page

Installation Steps

Remove the corresponding fasteners from the rubber trim piece. This is necesary in order for the hood shield flanges to slide under the

rubber trim piece. NOTE: It may be necessary to remove additional fasteners in order to accomodate the flange, depending on size.

Position the hood shield with the flanges sliding between the hood

and rubber seal. Align holes.

Insert (6) screws through rubber trim and into recep-

tacles and apply pressure while tightening screw to

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.

Congratulations!

You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in

our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top

quality in terms of fit, durability, finish and ease of installation.

NOTE: Actual application may vary slightly from illustrations.

secure to hood.

hood shield

receptacle

rubber

screw

Insert (6) receptacles UNDER rubber trim and through

Lower hood, adjust hood bumper stops to ensure

hood shield clears grille and headlights. Install bump

ons at pre-cleaned locations on the painted hood/

trim

Page 2 of 2

Discover various stone and bug deflectors in our online store.

front edge of

hood

fastener

rubber trim

hood shield, and then into hood.

rubber trim

receptacle

fender surface.

hood shield