AVS Carflector Installation Instructions Manual - Page 2

Print Page

Installation Steps

Locate the hex screw studs along the underside that

attaches the top of the grill to the hood. Loosen, but do

not totally remove the screws.

Silde the hood shield between the hood and grill

and center. Replace and retighten previously

loosened hex screws.

Place (1) bump-on on the leading edge of the

fender above headlight 9.5" from edge of grill.

Headlight

Tab should be positioned snugly behind headlight

assembly.

NOTE: Actual application may vary slightly from illustrations.

9.5" (24 cm)

Page 2 of 3

Lower the hood, and pivot the grill forward to create

a 1/8" (.32 cm) gap between hood and grill.

Fender Protector

Installation

Slide the headlight tab behind the main headlight

assembly.

Headlight tab

It is necessary to expose the sheet metal flange of

the hood by releasing the rubber seal nearest the

grill. Discard the (2) plastic fasteners.

Remove side marker light by removing

the (1) screw directly underneath the

light and sliding light forward..