AVS Ventvisor Installation Instructions Manual - Page 2

Print Page

Installation Steps

Clean painted door frame and mirror cap.

Apply surface prep to shaded areas.

DO NOT APPLY TO PAINT.

(Perform task for both sides of vehicle)

CAUTION: Read surface prep warning

on page 1 before continuing.

Attach visor to door. Front flange attaches to

outside of mirror cap, top flange to painted

surface, and rear flange to door post.

Apply pressure to tape flanges to secure.

NOTE: Actual application may vary slightly from illustrations.

Hold visor in place and mark front and rear

flange locations with masking tape.

Remove tape liner from front & rear flanges. Peel back

2" (5 cm) of tape liner from each end of top flange.

Repeat Steps 1-7 for passenger side

Page 2 of 4

Remove tape liner.

front visor.