Allied Telesis Series Release Note - Page 7

Browse online or download pdf Release Note for Switch Allied Telesis Series. Allied Telesis Series 7 pages. Allied telesis, inc switch software maintenance release note

Print Page

Version 89273-02 for AT-8900 and AT-9900 series switches

Software Maintenance Release note for Software Release 2.7.3

C613-10443-00 REV A

Level 4

CR00006093

Module: FFS

There was not enough information displayed to the user when the

ACTIVATE FLASH COMPACTION command was entered at the same time

as Flash was compacting.

This issue has been resolved. (No PCR number.)

Enhancements

CR00006652

Module: IKMP, IPSEC

Previously ISAKMP NAT-T was enabled by default on every ISAKMP

policy created. NAT-T is now disabled by default on every ISAKMP policy.

(No PCR number.)

CR00006953

Module: PPP

The ability to configure Van Jacobson Header Compression over dynamic

PPP interfaces has been added. To this end, the command parameter

'VJC={ON|OFF}' has been added to the CREATE and SET PPP TEMPLATE

commands. (No PCR number.)

CR00008045

Module: SWMX

Add support for the MG8T (Agilent QBCU-5730R) to support 10/100/1000

modes of operation.

CR00008367

Module: FIREWALL

Support has been added for VoIP services using SIP (port 5060) where the

VOIP phone's session setup is 5 packets or less and the keepalive is greater

than 5 min.

Note: If the keepalive is greater than the default udpTimeout of 20 minutes, then this

will need to be configured for the firewall policy.

Features in 89273-01

No release.

Level: 4