DG PCIe-SATA Manual

Browse online or download pdf Manual for Adapter DG PCIe-SATA. DG PCIe-SATA 2 pages. Conversion adapter

Print Page

PCIe-SATA conversion adapter[AB01-PCIe2SATA]

Introduction

Thank you for choosing PCI-Express_to_SATA conversion adapter [Part Number: AB01-PCIe2SATA] ("SATA

adapter" in this manual.)

The SATA adapter is interface conversion board between 1-lane PCI-Express and SATA so that user can evaluate

SATA-IP from DesignGateway.

User can evaluate real SATA interface operation by the SATA adapter along with FPGA Evaluation board such as

SP-605 from Xilinx and SATA SSD/HDD device.

Board Appearance

The SATA adapter board size is 18mm width and 44mm length. 1-Lane PCIe connector and SATA Host connector is

mounted on the component side. Following figure-1 shows SATA adapter appearance.

Connection to the FPGA board

Connect the SATA adapter with 1-Lane PCIe connector on the FPGA evaluation board and also connect SATA

connector with general SATA cable.

When user want to use FPGA as a SATA device and connect with SATA port of the PC, it needs signal channel

swapping between TX and RX. In this case, insert SATA crossover adapter (Part No.: AB02-CROSSOVER) from

DesignGateway between SATA connector and SATA cable.

Disclaimer

DesignGateway is exempted from any damage to the connected SATA device or FPGA board.

[Inquiry]

URL :

http://www.design-gateway.com/

Email :

Manual

1-Lane PCIe connector (Connect

with 1-Lane PCIe of FPGA board)

Figure-1: AB01-PCIe2SATA board appearance

[ Ver1.0E]

SATA Host connector

(Connect with SATA cable)

Page 1/2