DG Flugzeugbau DG-1001 Building Instructions - Page 5

Browse online or download pdf Building Instructions for Toy DG Flugzeugbau DG-1001. DG Flugzeugbau DG-1001 6 pages. All fiberglass 1/8 scale sailplane

Print Page

Attach the servos with two-sided Scotch tape to the channel and join them with the dive flap

using a draw rod. You will need extension cables and a Y-cable.

Shade your spoiler by pushing slightly with a small flat screwdriver on the arms of the bar (black

parts). Pull the Z of the manoeuvring on the gilded part and insert it into the interlocking hole

connecetd with the bottom of the servo. Shade again your spoiler and screw down your clevis at

the end of the manoeuvring. Demonstrate your servo heeding that the manoeuvring arm of the

servo is in the position of closed spoilers of your radion manoeuvring. (Example full gas on the

way of the engine manoeuvring of your radio) Adjust your manoeuvring and glue your servo

after having checked that both spoilers servos are moving in the right direction. Cover the servos

with the sheet.

7. Assembly of winglets

The winglest shall be glued to the wing ends. If it is necessary, chance the size of the gap in

order to insert winglet. Apply epoxy resin, insert winglet into the rib and leave it to get dry.

glue

8. How to install the radio and batteries

Insert the batteries, power switch and receiver in the fuselage .Connect all the servos in the

fuselage with the radio. Use a Y-cable to connect the aileron servos to one channel only or use

two channels, if available, for ailerons. Use a Y-cable to flaps servos and brakes servos.

Use foam to protect them from vibrations and impacts. Connect all components as necessary.

9. Assembling and finishing the model

Glue the brass pipe for the wing coupling into the fuselage. The wing halves can be secured in

the right position either by self-adhesive tape or using a rubber ring. In this case make 1.8 mm

holes in the first wing ribs and screw in the hooks for the fixing rubber ring. Drill the holes in the

proper position in the fuselage for the rubber ring.

Applying the decorative stickers is the last step to finish your model.