Allied Telesis AR400 Series How To Configure - Page 4

Browse online or download pdf How To Configure for Network Router Allied Telesis AR400 Series. Allied Telesis AR400 Series 6 pages. How to set up pppoe between a linux client and access concentrator
Also for Allied Telesis AR400 Series: Troubleshooting Manual (8 pages), Troubleshooting (5 pages), Quick Install Manual (8 pages), Quick Install Manual (12 pages), Safety Information Manual (18 pages), How-To (8 pages)

Print Page

An example scenario for RIP over L2TP

Routing Considerations

A routing issue to consider in this set up is the fact that RIP is relatively slow to react to

route changes as it only updates, by default, every 30 seconds.

To improve the responsiveness of RIP you can alter the default timers for updating, flushing

and so on. You do need to keep in mind that if you lose some packets (quite possible across

a lossy Internet connection) some of your routes may flap too much. So the RIP timers need

to be adjusted to provide an optimal compromise between responsiveness and robustness.

In this particular example, the various RIP timers are set at half default value.

set ip riptimer update=15 invalid=90 holddown=60 flush=150

Consideration would need to be given to each specific set up to get an optimal balance when

adjusting these timers.

Page 4 | AlliedWare™ OS How To Note: Dynamic Routing over L2TP