DGF Fabrications N2 Installation & Maintenance Instructions Manual - Page 13

Browse online or download pdf Installation & Maintenance Instructions Manual for Indoor Fireplace DGF Fabrications N2. DGF Fabrications N2 14 pages. Gas effect fires (natural gas & lpg) for decorative purposes only

Print Page
Pilot goes out when knob is released, or goes out at regular intervals
Check that the thermocouple is not loose.
•
Thermocouple is damaged and needs replacing.
•
Thermocouple operated magnetic valve faulty – replace gas valve
•
Blue flame
It normally takes 20 minutes for the fire to reach correct working temperature, by which time most of
•
the blue flames should have gone. Continuous blue flame is caused by poor coal layout or excessive up
draught of the flue. Seek advice from your manufacturer.
Poor gas pressure will also cause blue flame. Check gas pressure.
•
Poor Flame picture
Check gas pressure
•
Ensure that there is no obvious obstruction to gas supply pipe
•
Re-lay the simulated coals, pebbles, logs or driftwood as shown on the relevant illustrations within this
•
booklet. Only do this when fire is cold or alternatively use a non combustible tool.
These fires are made in Darlington and there destinations are distributed throughout England, Ireland, Scotland,
Wales, Isle of Wight, and Spain. (GB – IE – ES).
Units 1-3 Vulcan St, Edward St Industrial Estate, Darlington. DL1 2UL – Tel: 01325 281304; Fax: 01325 481889
COUNTRY OF DESTINATION
13
DGF Fabrications;