Avtech KPC131 User Manual - Page 4
Browse online or download pdf User Manual for Security Camera Avtech KPC131. Avtech KPC131 4 pages. Regular camera series
Print Page
INSTALLATION
***The following installation is better accomplished by qualified service personnel or system installer.***
1. Mount a lens onto the camera (By turning it clockwise).
It is suitable for CS-mount lens.
But if the lens you chose is C-mount, please use the supplied CS-C conversion ring to connect the C-mount
lens and the camera.
If the lens you chose is
2. Switch the lens selection depending on the lens you used.
* Manual iris lens or fixed lens:
AES: When using manual iris lens or fixed iris lens, set switch to AES.
* Auto iris lens:
AI: When using auto iris lens, set switch to AI.
V.D. / D.D.: When using Auto Iris Lens, select VD or DD depend on the type of lens you used.
3. Connect the camera VIDEO output and the monitor video input with a 75Ω coaxial cable.
4. Connect the camera AUDIO output and the monitor audio input with a coaxial cable.
5. Connect the POWER terminal of the camera to a right power supply.
6. Adjust the focus or flange-back (Please refer to
NOTE 1: Auto Iris Lens Connector Installation
Cut the iris control cable at the edge of the lens connector to remove the existing lens connector.
Remove the outer cable cover of the supplied connector as shown in the diagram.
The pin assignment of the auto iris lens connector is as follows:
Auto Iris Lens
Pin 1:
Power source
Pin 2:
Video signal
Pin 3:
Not used
Pin 4:
Ground, Shield
Solder the lens cable to the pins of the supplied connector
NOTE 2: Focus or Flange-Back Ring Adjustment
1. Mount the lens
by turning it clockwise on the lens mount of the camera.
2. Loosen the screws on the flange-back adjusting ring.
3. Turn the flange-back adjusting ring to the desired position.
4. Tighten the screws on the flange-back adjusting ring.
PRECAUTIONS
Do not install the camera in an environment where the humidity or temperature is high
Do not install the camera under the unstable lighting condition
Do not expose the camera to rain or moisture
Do not keep the camera face to strong light directly
Do not touch the front glass of the camera
Do not use other than specified power source
Do not disassemble the camera
auto iris lens, please refer to
V.D.
D.D.
Damp
Damp
Driver
Driver
N
N
O
O
T
T
E
E
1 for installation instructions.
1
N
O
T
E
2 for adjustment instructions).
N
O
T
E
2
Flange Back Adjusting Ring
Back focal lock hexagonal bolt