Dell 1555 - Studio - Chainlink Service Manual - Page 11

Browse online or download pdf Service Manual for Laptop Dell 1555 - Studio - Chainlink. Dell 1555 - Studio - Chainlink 50 pages.
Also for Dell 1555 - Studio - Chainlink: Service Manual (50 pages)

Dell 1555 - Studio - Chainlink Service Manual
Back to Contents Page
  Processor Module
Dell Studio™ 1555 Service Manual 
  Removing the Processor Module
  Replacing the Processor Module
 
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the back panel) on the computer.
 
CAUTION:
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
to apply slight pressure to the center of the processor while turning the cam screw.
 
CAUTION:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
inside the computer.
 Removing the Processor Module
 
1. Follow the instructions in
Before You
 
2. Remove the processor heat sink (see
 
3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1 ZIF-socket cam screw 2 ZIF socket
 
CAUTION:
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The
oils in your skin can reduce the heat transfer capability of the thermal pads.
 
CAUTION:
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
 
4. Lift the processor module from the ZIF socket.
 Replacing the Processor Module
Begin.
Removing the Processor Heat
Sink).
Before Working Inside Your
Computer) before working