Dell E Series Installation Instructions - Page 4

Browse online or download pdf Installation Instructions for Laptop Dell E Series. Dell E Series 5 pages. Vesa mounting bracket
Also for Dell E Series: Training (43 pages), Service Manual (25 pages)

Print Page

Mounting the Wyse P25 and T Class to the E Series Monitor

Use the following instructions to mount the P25 or T class cloud client to the Dell E

Series Monitor VESA Mounting Bracket.

1. Preparing the cloud client:

2. Remove the four (4) VESA screws from the back of the monitor and set them aside.

a. Remove the cloud client from its horizontal stand/VESA bracket. On the 'inside'

of the stand/bracket, slip one of the four (4) provided nuts into a screw hole.

Tip: Use your finger to slide the nut across the stand/bracket surface so that it

easily slips into the recessed cutout.

b. Using a Phillips-head screwdriver, attach one of the four (4) shoulder screws

through the 'outside' screw hole and into the nut (do not over-tighten). Repeat

for remaining three nuts and shoulder screws.

c. Finally, insert the cloud client into the stand/bracket as shown, with the power

button at the top, and the extended plastic ledge on the opposite side.

Position the monitor bracket on the back of the monitor and attach it using the

same VESA screws (do not over-tighten).

Tip: For ease of attaching the screws, you may want to place the E Series Monitor

face down on a padded table, with the foot of the stand hanging over the table's

edge.