Dell Inspiron 600m Service Manual - Page 11

Browse online or download pdf Service Manual for Laptop Dell Inspiron 600m. Dell Inspiron 600m 41 pages. Hard drive
Also for Dell Inspiron 600m: Start Here (2 pages), Start Here (2 pages), Start Here (2 pages), Getting Started Manual (2 pages), User Manual (34 pages), Setup Manual (2 pages), Getting Started (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Media Base User's Manual (26 pages), Service Manual (40 pages), Service Manual (41 pages), Installing And Configuring (38 pages), Quick Start (2 pages), Quick Start (2 pages), Quick Start (2 pages), Setting Up Your Computer (2 pages), Service Manual (41 pages), Service Manual (4 pages)

Print Page
Dell Inspiron 600m Service Manual
Back to Contents Page

Display Assembly and Display Latch

Dell™ Inspiron™ 600m Service Manual
  Display Assembly
  Display Bezel
  Display Panel
  Display Latch
Display Assembly
 
CAUTION:
Before performing the following procedures, read the safety instructions in your Owner's Manual.
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
 
NOTICE:
You must remove the display assembly before you remove the palm rest.
1.  Follow the instructions in
"Preparing to Work Inside the
2.  Remove the keyboard.
3.  Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.
4.  Loosen the captive screw that secures the display cable to the system board, and release the cable from the four cable-routing clips.
 
 
 
 
 
1 display
2 cable-routing clips (4)
3 display cable connector
5.  Pull up on the pull-tab that is attached to the display cable connector to remove the connector from the system board.
6.  Remove the three M2.5 x 6-mm screws.
7.  Rotate the display assembly to a 90-degree angle, and lift the display assembly up and out of the computer base.
Computer."