Dell Inspiron 600m Service Manual - Page 9

Browse online or download pdf Service Manual for Laptop Dell Inspiron 600m. Dell Inspiron 600m 41 pages. Hard drive
Also for Dell Inspiron 600m: Start Here (2 pages), Start Here (2 pages), Start Here (2 pages), Getting Started Manual (2 pages), User Manual (34 pages), Setup Manual (2 pages), Getting Started (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Service Manual (41 pages), Media Base User's Manual (26 pages), Service Manual (40 pages), Installing And Configuring (38 pages), Quick Start (2 pages), Quick Start (2 pages), Quick Start (2 pages), Setting Up Your Computer (2 pages), Service Manual (41 pages), Service Manual (4 pages)

Print Page
Dell Inspiron 600m Service Manual
Back to Contents Page

Microprocessor Module

Dell™ Inspiron™ 500m Service Manual
Removing the Microprocessor Module
 
CAUTION:
Before performing the following procedures, read the safety instructions in your Owner's Manual.
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
 
NOTICE:
Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam
screw to prevent intermittent contact between the cam screw and microprocessor.
 
NOTICE:
To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.
1.  Follow the instructions in
"Preparing to Work Inside the
2.  Remove the keyboard.
 
NOTICE:
To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the microprocessor thermal-cooling assembly. The
oils in your skin reduce the heat transfer capability of the thermal pads.
3.  Remove the
microprocessor thermal-cooling
 
NOTICE:
When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.
4.  To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
 
 
1
ZIF socket
2
pin-1 corner
 
NOTE:
The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.
5.  Lift out the microprocessor module.
Installing the Microprocessor Module
 
NOTICE:
Ensure that the cam lock is in the fully open position before seating the microprocessor module. Seating the microprocessor module properly in
the ZIF socket does not require force.
 
Computer."
assembly.