DH electronics 96Boards Avenger96 Getting Started - Page 11

Browse online or download pdf Getting Started for Motherboard DH electronics 96Boards Avenger96. DH electronics 96Boards Avenger96 14 pages.
Also for DH electronics 96Boards Avenger96: Getting Started (19 pages)

Print Page
Avenger96 – Getting Started

1.2 Set Up Guide

This short guide leads you through the first steps to start exploring your Avenger96.
In the Box you can find the Avenger96 as well as a microSD card which comes with a pre-installed linux.

1.2.1 Easy step by step guide

The board can be put in operation by following steps:
Make sure the boot switch is set to boot from the "SD-Card (Standard)" (See chapter 1.2.2)
Insert the included microSD card with pre-installed linux
Connect an display via the HDMI-connector
Connect keyboard and mouse to the host USB ports
Connect a proper power supply (See chapter 1.2.3)
Plug the power supply into the power socket

1.2.2 Boot Mode

The Avenger96 supports multiple boot options which are selected by the
DIP-switch S3. To select a logical "1" a switch needs to be pushed to the
right. Therefore a logical "0" is set by pushing the switch to the left. The nu-
meration of these pins is printed next to the switch on the circuit board.
BOOT Mode
UART and USB
NOR-Flash
eMMC
NAND-Flash
(Not available)
Reserved (NoBoot)
SD-Card
(Standard)
UART and USB
Serial NAND Flash
(Not available)
R05
Comments
USB high-speed Device
On Quad SPI
On SDMMC2
SLC NAND Flash
Get boot access without boot
from Flash memory
On SDMMC1
USB OTG
NAND flash on Quad SPI
DOC_Getting-Started-588-100.docx
Switch 1 - BOOT 2 Switch 2 - BOOT 1 Switch 3 - BOOT 0
0
0
0
0
1
1
1
1
DH electronics GmbH
0
0
0
1
1
0
1
1
0
0
0
1
1
0
1
1
Page 11 / 14