Dell 2707WFP - UltraSharp - 27" LCD Monitor User Manual - Page 32
Browse online or download pdf User Manual for Desktop Dell 2707WFP - UltraSharp - 27" LCD Monitor. Dell 2707WFP - UltraSharp - 27" LCD Monitor 49 pages. Flat panel monitor
Also for Dell 2707WFP - UltraSharp - 27" LCD Monitor: Setup Manual (2 pages), Fact Sheet (4 pages)
Print Page
If either VGA or DVI-D input is selected and both VGA and DVI-D cables are not connected, a floating dialog box as shown below appears.
If either S-Video or Composite input is selected and both cables are not connected or the video source is turned off, the screen does not have an
image. If any button is pressed (except power button), the monitor displays the following message:
B
Use this button to activate PIP (Picture-in-Picture) / PBP (Picture-by-Picture) modes adjustment.
Pressing this button continually cycles the monitor through the following modes : OFF-->PIP-->PBP. You will see the following messages
corresponding to the mode selected.
PIP / PBP Select
C
The MENU button is used to launch the on-screen display(OSD) and select the OSD Menu. See
OSD Menu / Select
D
Use this button for direct access to the "Brightness" and "Contrast" control menu.
Brightness/Contrast
Hot Key
D
Use these buttons for navigating and adjusting the slider-bar(decrease/increase ranges) controls in the OSD.
,E
Down (-) and Up (+)
E
Use this button to activate automatic setup and adjust menu. The following dialog appears on a black screen as the monitor self-adjusts to the
current input:
Auto Adjust
Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can further tune your monitor
by using the Pixel Clock (Coarse) and Phase (Fine) controls under Image Settings.
NOTE: Auto Adjust will not occur if you press the button while there are no active video input signals or attached cables
OR
OR
→
Accessing the Menu
System.