Allied Telesis 86241-02 Release Note - Page 7

Browse online or download pdf Release Note for Software Allied Telesis 86241-02. Allied Telesis 86241-02 12 pages. Patch for rapier switches and ar800 series modular switching routers

Print Page

Patch 86241-02 For Rapier Switches and AR800 Series Modular Switching Routers

Patch 86241-02 for Software Release 2.4.1

C613-10340-00 REV B

PCR: 02365

Module: SWI

Address learning on the mirror port is now correctly re-enabled when it is

no longer the mirror port.

PCR: 02367

Module: SWI

New commands have been added to enable the addition and deletion of

static multicast addresses to and from the multicast forwarding table. The

new commands are:

ADD SWITCH MULTICASTADDRESS IP=ipadd VLAN=vlan-id

PORT=port-list

DELETE SWITCH MULTICASTADDRESS IP=ipadd VLAN=vlan-id

PCR: 02369

Module: IPG

When the SET IP ROUTE command was executed to change any parameter

other than METRIC1, which is the RIP metric, the RIP metric was reset to 1.

This metric is now only updated if a value for the parameter is specified.

PCR: 02371

Module: FIREWALL

When the system time was set to a time that was before or significantly after

the current time, Firewall sessions were prematurely deleted. This issue has

been resolved.

PCR: 02376

Module: PPP

When the PPP ONLINELIMIT was exceeded for PPP over TDM, the PPP

link stayed open, allowing Link Quality Report (LQR) packets to be

transmitted. This caused the ifOutOctets counter to increment. Now, if the

ONLINELIMIT is exceeded, the link will close.

PCR: 02378

Module: SWI

Entering 63 for the EPORT parameter in the ADD SWITCH L3FILTER

command caused a fatal error. This parameter now accepts the values 63

and 64.

PCR: 02395

Module: VRRP, TRG

The SHOW VRRP command now shows the number of trigger activations

for the Upmaster and Downmaster triggers.

PCR: 02397

Module: DVMRP

After a prune lifetime had expired, the interface was not joined back to the

DVMRP multicast delivery tree. This issue has been resolved.

PCR: 02398

Module: IPV6

The following issues have been resolved:

•

It was possible to assign the same network on different IPV6 interfaces

•

The loopback address was being added to other interfaces

•

The tunnel configuration was not showing correctly in IPV6

configuration commands

RIPv6 now sets the metric of routes for interfaces that are DOWN to 16, and

immediately sends responses when the link status of VLAN interfaces

changes.

Network affecting: No