Allied Telesis AR400 Series Troubleshooting

Browse online or download pdf Troubleshooting for Software Allied Telesis AR400 Series. Allied Telesis AR400 Series 5 pages. How to set up pppoe between a linux client and access concentrator
Also for Allied Telesis AR400 Series: How To Configure (6 pages), Troubleshooting Manual (8 pages), Quick Install Manual (8 pages), Quick Install Manual (12 pages), Safety Information Manual (18 pages), How-To (8 pages)

Print Page

Best Practice |

Introduction

This How To Note describes techniques for on-site debugging. It is in no way intended to be

a comprehensive guide to debugging Allied Telesis equipment. Instead, it is aimed at passing

on some techniques that have been found to be useful. Particularly, this document describes

techniques which:

make it less likely that you will miss important pieces of information

make it simpler for someone else to analyse the debug information that you capture

enable you to be more accurate in after-the-event discussions of what you saw.

Which products does it apply to?

This document applies to the following Allied Telesis routers and managed layer 3 switches:

AR300, AR400, and AR700 series routers

AT-8600, AT-8700XL, AT-8800, Rapier, and Rapier i series switches

AT-9800 series switches

AT-8900, AT-9900, and AT-9900s series switches

x900 series switches

SwitchBlade series switches

Related How To Notes

You also may find the following How To Notes useful, because they specifically discuss how to

debug connections:

How To Troubleshoot ISDN Connections

How To Troubleshoot VPNs

Note that many other How To Notes include troubleshooting information as well as

configuration examples.

How To Notes are available from www.alliedtelesis.com/resources/literature/howto.aspx.

C613-16028-00 REV B

On-Site Debugging