Allied Telesis AR441S Release Note - Page 9
Browse online or download pdf Release Note for Software Allied Telesis AR441S. Allied Telesis AR441S 14 pages. 54266-02 patch release note
Also for Allied Telesis AR441S: Release Notes (6 pages)
Patch 54266-02
Patch 54266-02
C613-10417-00 Rev B
Main system
Main features of the AR440S routers are:
■
300 MHz RISC processor.
■
64 MBytes of SDRAM.
■
16 MBytes of flash memory (1 MByte reserved for boot block code).
■
5 x 10/100 Mbps full duplex, Layer 2 switched Ethernet LAN ports. All
LAN ports have Auto-MDI, however if Auto-MDI is turned off, then all
ports are hardwired as MDI-X. Software can also force a port to either MDI
or MDI-X. 802.1Q tagged VLANs are supported.
■
1 x ADSL Annex B port
■
1 x asynchronous DTE port.
■
Universal AC power supply.
■
On-board hardware encryption processor for DES, 3DES and AES.
Some encryption options may require feature licenses.
The RS-232 asynchronous serial port (ASYN 0) has a DB9 male connector, is
wired as a DTE port and can be used as a general purpose port for terminals,
printers or modems. The default communications settings are:
•
9600 bps
•
8 data bits
•
1 stop bit
•
no parity
•
hardware flow control
ADSL Interfaces
The ADSL port has an RJ11 connector, and supports Dying Gasp.
Power supply
The routers have a universal AC input connector and a power switch on their
rear panel. The routers require a power input of 100-240 VAC and 50–60Hz.
Some interfaces that may be installed in the router are not transformer isolated.
This means they will be referenced to the frame ground of the equipment and
may be damaged if connected to an interface on another piece of equipment
which is at a different ground potential.
For more information about the hardware, see the AR400 Series Hardware
Reference on the Documentation and Tools CD-ROM.
Features in 54266-01
Patch file details are listed in
Table
2.
9