Dell Dimension 2200 Manual - Page 19

Browse online or download pdf Manual for Server Dell Dimension 2200. Dell Dimension 2200 50 pages. Vga card installation instructions
Also for Dell Dimension 2200: Replacement Manual (9 pages), Installation Instructions (1 pages)

Print Page
Dell Dimension 2200 Manual
13.  Install any drivers required for the card as described in the card documentation.

Removing Cards

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
 Remove the computer
cover.
5.
 Rotate the power supply
away from the system board.
6.  Disconnect any cables connected to the card.
7.  Remove the screw from the card bracket.
8.  Grasp the card by its top corners, and lift it from the system board.
9.  If you are removing the card permanently, reinstall a filler bracket.
10.
 Rotate the power supply
back into place.
11.
 Replace the computer
cover.
12.  Plug your computer and devices into their electrical outlets, and turn them on.
NOTICE:
To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.

Adding Memory

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
You can increase your computer memory by installing memory modules on the system board. For information on the type of memory supported by your
computer, look under "Memory" in "Technical Specifications."
HINT:
Memory purchased from Dell is covered under your computer warranty.
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
 Remove the computer
cover.
5.
 Rotate the power supply
away from the system board.
6.  If necessary, remove a memory module:
a.  Press out the securing clip at each end of the memory connector.
b.  Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
7.  To insert a module, press out the securing clip at each end of the memory connector.
 
"Safety
Instructions."
"Safety
Instructions."