Dell Dimension 2400 Series Manual - Page 19

Browse online or download pdf Manual for Server Dell Dimension 2400 Series. Dell Dimension 2400 Series 43 pages. Vga card installation instructions
Also for Dell Dimension 2400 Series: Quick Setup Manual (2 pages), Quick Setup Manual (2 pages), Installation Manual (20 pages), Install Manual (8 pages), Rack Installation Instructions (32 pages), Installation Instructions (1 pages)

Print Page
Dell Dimension 2400 Series Manual
8.  Insert the module into the connector until the module snaps into position.
 
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
 
9.
 Replace the computer
cover.
 
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
10.  Connect your computer and devices to electrical outlets, and turn them on.
11.  Right-click the My Computer icon and click Properties.
12.  Click the General tab.
13.  To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
 

Removing Memory

 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information
Guide.
 
NOTE:
Memory purchased from Dell is covered under your computer warranty.
1.
 Shut down the computer
through the Start menu.
2.  Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your computer, turn them off now.
 
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect any telephone or telecommunication lines from the computer.
4.  Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.
 
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
5.
 Remove the computer
cover.
6.  Press out the securing clip at each end of the memory module connector.
7.  Grasp the module and pull up.
 
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
Back to Contents Page