Avtron K711D36027 Manual - Page 6

Browse online or download pdf Manual for Industrial Equipment Avtron K711D36027. Avtron K711D36027 17 pages.

Print Page

Installation

INSTALLATION CHECKOUT PROCEDURE -

TO BE DONE PRIOR TO OPERATION

This Installation Checkout Procedure is intended to be used upon initial receipt of equipment and

following any relocation of a permanent mounted Load Bank. These procedures apply to Load

Banks in general and may include steps not relevant to the specific unit being installed. Disregard

those procedures which do not apply.

*************************************************************

THE FOLLOWING TESTS ARE TO BE ACCOMPLISHED BY A

QUALIFIED

EXTREME CAUTION AS POTENTIALLY LETHAL VOLTAGES

AND

PRESENT. IF ASSISTANCE IS REQUIRED, AVTRON CAN

PROVIDE START UP SERVICE AT A NOMINAL CHARGE.

AVTRON ALSO WILL PROVIDE TELEPHONE ASSISTANCE IF

REQUIRED BY CALLING (216) 641-8310.

*************************************************************

Verify the Load Bank placement meets the installation requirements found in the

INSTALLATION section of the instruction manual:

Check the clearance from both intake and exhaust to any obstruction.

If the location has a prevailing wind, make the wind aid in the cooling of the resistor

elements.

Duct exhaust air outdoors via a customer-supplied exhaust hood which, along with

intake losses, creates no more than 0.25" total system static pressure (pressure drop).

Check the mechanical integrity of all customer-supplied interconnection wiring:

Check lugs that they are properly crimped.

Check terminations that they are properly torqued.

Utilize system schematics to ohm out customer-supplied interconnection control wiring and

safety circuits:

SECTION III

INSTALLATION

W A R N I N G

ELECTRICIAN

DANGEROUS

ROTATING

Avtron Load Bank • Part Number K711D36027

TECHNICIAN

COMPONENTS

3-1

USING

ARE