Chris King R45 DISC Manual - Page 4

Browse online or download pdf Manual for Bicycle Accessories Chris King R45 DISC. Chris King R45 DISC 20 pages. Hub
Also for Chris King R45 DISC: User Manual (16 pages)

Print Page

Hub Identifi cation and Attachment Type

Two Piece Axle

The two piece axle uses an adjusting cone to adjust bearing preload and an axle end to lock

the preload adjustment. Hubs that are factory assembled with the two piece axle include: R45

front, Classic front, Classic 130/140mm rear, Classic Cross front and Classic Cross rear. Two

piece axle disassembly, reassembly and adjustment procedures can found on pages 5,

6 and 7. The two piece axle design (see Fig. 1, pg. 2) is designed for a skewer-type retention

device and must not be modifi ed or altered to accept any type of bolt-on retention device.

One Piece Axle

The one piece axle uses an adjusting clamp to adjust the hub bearing preload. Hubs that are

factory assembled with the one piece axle include: R45 rear, Single Speed, BMX front, BMX

rear and Classic 135/160 rear. Classic rear hub axles can be converted from 130/135mm two

piece to 130/135mm one piece. One piece axle disassembly, reassembly and adjustment

procedures can found on pages 6, 7, and 8. See R45 Hub Information section on pages 14 and

15 for hub R45 specifi c information.

One piece and two piece axles are interchangeable on 135mm rear hubs. For details on axle con-

versions, please refer to the hub specifi cations table on pages 16 and 17, call our Technical Services

Department at 800.523.6008, or check out our web site for tech info and videos: www.chrisking.com

• FunBolts

(see Figure 3)

Chris King FunBolts are hollow, stainless steel bolts that can be used as a retention device

in conjunction with standard 10mm slot-width rear dropouts with the 130/135mm one piece

rear axle. FunBolts should be tightened to 25 foot-pounds of torque using an 8mm hex

wrench.

• QR Adaptors

Chris King QR Adaptors allow for the use of a skewer-type retention device with the 130/135/145/160mm

one piece rear axle. The adaptors are threaded into both ends of the axle using a 5mm hex

wrench.

(see Figure 1)

Axle End

Adjusting

Cone

(see Figure 2)

2.5mm

hex bolt

Adjusting

Clamp

FunBolts

Figure 3

(see Figure 4)

Two Piece Axle

Figure 1

One Piece Axle

Figure 2

QR Adaptors

Figure 4