Dell EMC PowerProtect DD6400 System Expansion Manuallines - Page 35

Browse online or download pdf Expansion Manuallines for Server Dell EMC PowerProtect DD6400 System. Dell EMC PowerProtect DD6400 System 46 pages.

Print Page

system show eula

Run the configuration wizard

There are two wizards, a DD System Manager configuration wizard and a Command Line Interface (CLI) configuration wizard.

The configuration wizards guide you through a simplified configuration of the system to get the system operating quickly.

Command Line Interface (CLI) configuration wizard

The CLI configuration wizard starts automatically the first time the system starts. The wizard prompts you through a series of

questions that provide just enough information for initial system configuration and basic network connectivity.

You can begin the CLI configuration wizard manually by typing config setup.

After you complete the basic configuration with a wizard, you can use additional configuration controls in DD System Manager

and the CLI to further configure the system.

DD System Manager configuration wizard

DD System Manager provides a single, consolidated management interface that allows for configuration and monitoring of many

system features and system settings.

Prerequisites

To avoid IP address conflicts with the DDOS-iDRAC interconnect, do not configure 169.254.0.<X> and 169.254.1.<X> IP

addresses.

Steps

1. Enter yes to configure the system for network connectivity.

Network Configuration

Configure Network at this time (yes|no) [no]:

yes

2. Enter yes to configure DHCP (Dynamic Host Configuration Protocol) to obtain network parameters (such as, the host

name, domain name, and IP addresses) dynamically from a DHCP server. Or enter no to configure the parameters manually.

Use DHCP

Use DHCP for hostname, domainname, default gateway

and DNS servers? (At least one interface needs to

be configured using DHCP)

3. Enter a fully qualified domain name (FQDN) for the host name; for example, str01.yourcompany.com. Or accept the

host name, if the system was able to discover it.

Enter the hostname for this system

(fully-qualified domain name)[]:

4. Enter the DNS (Domain Name System) domain name; for example, yourcompany.com. Or accept the domain name, if the

system was able to discover it.

Domainname

Enter your DNS domainname []:

5. Enable and configure each Ethernet interface. Accept or decline DHCP for each interface. If the port does not use DHCP to

discover network parameters automatically, enter the information manually.

Ethernet port ethMa

Enable Ethernet port ethMa (yes|no|?) [no]:

yes

(yes|no|?)

Configure System for Use