Dell EMC PowerProtect DD6400 System Expansion Manuallines - Page 38

Browse online or download pdf Expansion Manuallines for Server Dell EMC PowerProtect DD6400 System. Dell EMC PowerProtect DD6400 System 46 pages.

Print Page

Configuring the system with the configuration wizard

The protection system provides two wizards: a DD System Manager configuration wizard and a Command Line Interface

(CLI) configuration wizard. The configuration wizards guide you through a simplified configuration of your system to get your

protection system operating quickly.

About this task

After you complete the basic configuration with a wizard, you can use additional configuration controls in DD System Manager

and the CLI to further configure your system.

NOTE:

The following procedure describes how to start and run the DD System Manager configuration wizard after the

initial configuration of your protection system. For instructions on running the configuration wizards at system startup, see

the Installation Guide for your system model.

NOTE:

To configure your system for HA, use the CLI Configuration Wizard. For more information, see the Installation Guide

for the HA-capable system.

Steps

1. Select Maintenance > System > Configure System.

2. Use the controls at the bottom of the Configuration Wizard dialog box to select which features to configure and to advance

through the wizard. To display help for a feature, click the help icon (question mark) in the lower left corner of the dialog

box.

The License section enables you add, modify, or delete licenses from a license file. DDOS supports licensing via the Electronic

License Management System (ELMS), which enables you to include multiple features in a single license file upload.

When using the Configuration Wizard on a system with no licenses configured, click Upload. Browse to the directory where the

license file resides, and select it for upload to the system.

Click Apply to add the license to the system.

The Network section is a read-only page that summarizes the general settings and configuration.

To make changes to the network settings after the Configuration Wizard is complete, select Hardware > Ethernet.

To avoid IP address conflicts with the DDOS-iDRAC interconnect, do not configure 169.254.0.<X> and 169.254.1.<X> IP

addresses.

The Passphrase section provides fields to specify and confirm the system passphrase. This is required to encrypt the encryption

keys, cloud keys, and secret keys.

Do not lose the system passphrase. It cannot be recovered.

Configure System for Use