Dell POWEREDGE 4300 Upgrade Manual - Page 17

Browse online or download pdf Upgrade Manual for Server Dell POWEREDGE 4300. Dell POWEREDGE 4300 24 pages. System board upgrade
Also for Dell POWEREDGE 4300: Installation Information (6 pages), Installation Manual (28 pages), Rack Installation (37 pages), Upgrade Installation Manual (14 pages), Rack Installation (34 pages), Upgrade Manual (23 pages), Installation Instructions Manual (12 pages), Replacement Manual (3 pages), Installation Information (6 pages), Installation Manual (14 pages)

Print Page
Dell POWEREDGE 4300 Upgrade Manual
support.dell.com
microprocessor
!
!" # ! $
%
To remove the guide bracket assembly, perform the following steps:
1.
Remove any terminator card installed in the guide bracket.
2.
Remove any microprocessor assembly installed in the guide bracket.
3.
Use a #2 Phillips screwdriver to loosen the four captive nuts that secure the
guide bracket assembly to the system board (see Figure 1-5).
4.
Lift up the assembly to remove it from the four threaded posts.
To install the new guide bracket assembly, perform the following steps:
1.
Position the guide bracket over the four threaded posts (see Figure 1-6).
You can install the guide bracket only one way (the captive nuts will not align
with the threaded posts if installed incorrectly).
2.
Tighten the four captive nuts using a #2 Phillips screwdriver.
Dell PowerEdge Systems — Microprocessor Upgrade
release latches (2)
thumbscrews (2)
heat sink
1-13