Dell PowerEdge 860 Service Manual - Page 10

Browse online or download pdf Service Manual for Server Dell PowerEdge 860. Dell PowerEdge 860 37 pages. Sas/raid controller installation
Also for Dell PowerEdge 860: Information Update (14 pages), Install Manual (28 pages), Installation Instructions Manual (7 pages)

Print Page
Dell PowerEdge 860 Service Manual
Back to Contents Page
  Processor
Dell™ Vostro™ A840/A860 Service Manual 
  Removing the Processor
  Replacing the Processor
 
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
 Removing the Processor
 
NOTICE:
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
to apply slight pressure to the center of the processor while turning the cam screw.
 
NOTICE:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
 
1. Follow the instructions in
Before You
 
2. Remove the heat sink (see
 
3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
The ZIF-socket cam screw secures the processor to the system board. Make a note of the arrow on the ZIF-socket cam screw.
1
processor
4
ZIF-socket cam screw
 
NOTICE:
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor heat sink. The oils in your skin can
reduce the heat transfer capability of the thermal pads.
 
NOTICE:
When removing the processor, pull it straight up. Be careful not to bend the pins on the processor.
 
4. Lift the processor from the ZIF socket.
 Replacing the Processor
 
Begin.
Processor Heat
Sink).
2
pin-1 corner of processor
 
 
3
ZIF socket