Allied Telesis AT-9800 Series Quick Install Manual - Page 5

Browse online or download pdf Quick Install Manual for Software Allied Telesis AT-9800 Series. Allied Telesis AT-9800 Series 12 pages. How to set up pppoe between a linux client and access concentrator
Also for Allied Telesis AT-9800 Series: Release Note (5 pages), How To Configure (9 pages), How-To (8 pages)

Print Page
Allied Telesis AT-9800 Series Quick Install Manual
Quick Install Guide
Figure 1: AT-9816GF front panel and rear panel with AC power inlet.
1
2
9
10
AC SUPPLY DATA
HZ
~
100-120/200-240
50/60
Input Vdc
+3.3
+5
+12
R.P.S.
INPUT
CLASS 1
LASER
AC Power
AT-RPS8000 RPS Connector
C613-04038-01 REV F
5.
Install CAM (Optional)
If you purchased a Content Addressable Memory (CAM) module, install it
now by following the instructions in the CAM Quick Install Guide.
The CAM Quick Install Guide can be found on the AT-9800 Series
Documentation and Tools CD-ROM, or can be downloaded from
www.alliedtelesyn.co.nz/support/at9800/.
6.
Place the switch in its operating location
If installing the switch in a rack:
•
Remove the rubber feet
•
Attach the rack-mounting brackets
•
Mount the switch in the rack
7.
Apply AC power to the switch (for AC models)
Plug the power cord into the AC power connector on the switch's rear
panel. The Fault LED should flash for approximately 10 seconds as the
switch runs internal tests.
If the LED continues to flash or remains lit, refer to the AT-9800 Series
Hardware Reference for troubleshooting information.
1000BASE-X GBIC
3
4
5
11
12
13
AMPS
4/2
A Max
13
8
1
6
7
8
14
15
16
PORT ACTIVITY
AT-9816GF
LINK / FULL DUP
ACTIVITY
L /A
L /A
L /A
L /A
Multi-Layer Gigabit Switch
LINK / HALF DUP
ACTIVITY
ENABLED
DISABLED
GBIC
L /A
GBIC
FAULT
RS-232
TERMINAL PORT
1
2
3
4
5
6
7
8
L /A
ASYN0
GBIC
L /A
GBIC
9
10
11
12
13
14
15
16
COMPACT FLASH
ACTIVITY
Compact FLASH
5
STATUS
FAULT
RPS
RESET
PWR