Dell PowerEdge M710 Technical Manualbook - Page 8

Browse online or download pdf Technical Manualbook for Server Dell PowerEdge M710. Dell PowerEdge M710 31 pages. Dell poweredge blade servers getting started guide
Also for Dell PowerEdge M710: Information Update (38 pages), Update Manual (44 pages), Update Manual (21 pages), Update Manual (14 pages), Installation Manual (7 pages), Update Manual (1 pages), Getting Started Manual (12 pages), Getting Started Manual (12 pages), Portfolio Manual (27 pages), Getting Started Manual (14 pages), Getting Started Manual (12 pages)

Print Page

Dell™ PowerEdge™ M710 Technical Guidebook

featuRe

Blade Power

Indicator

Blade Status/

Identification

Indicator

Blade Power

Button

USB Connector

icOn

DescRiPtiOn

Off – Power is not available to the blade, the blade is in standby

mode, the blade is not turned on, or the blade is installed

incorrectly. For detailed information on installing a blade, see

"Installing a Blade."

Green increasing from low brightness to full brightness – Blade

power on request is pending.

Green on – The blade is turned on.

Off – The blade power is off.

Blue – Normal operating state.

Blue Blinking – The blade is being remotely identified via the CMC.

Amber Blinking – Blade has either detected an internal error, or

the installed mezzanine card(s) does not match the I/O modules

installed in the M1000e enclosure. Check the CMC for an I/O

configuration error message and correct the error.

Turns blade power off and on.

• If you turn off the blade using the power button and the blade

is running an ACPI-compliant operating system, the blade can

perform an orderly shutdown before the power is turned off.

• If the blade is not running an ACPI-compliant operating system,

N/A

power is turned off immediately after the power button is pressed.

• Press and hold the button to turn off the blade immediately.

The blade power button is enabled by default by the System Setup

program. (If the power button option is disabled, you can only use

the power button to turn on the blade. The blade can then only be

shut down using system management software.)

Connects external USB 2.0 devices to the blade.