Allied Telesis AT-S87 Release Note - Page 2

Browse online or download pdf Release Note for Software Allied Telesis AT-S87. Allied Telesis AT-S87 4 pages. Version 1.0.0 at-gs950/48 gigabit ethernet smart switch

Print Page

Class of Service

STP and RSTP

Port Security

Statistics

Resolved Issues

The IP access list in SSM edit window now displays more than 11 entries.

When IGMP snooping, RSTP/STP and port trunking features are enabled, the three features

are now compatible and behave as expected.

When the name included a space for either a trunk member or a VLAN member, the

parameters on the respective feature were affected abnormally. This bug has been resolved.

The system is now stable and will not enter into a loop condition if the user switches the mode

between STP and RSTP.

The RMON counters now display the correct values.

During a firmware upgrade, the AT-GS950/48 Gigabit Ethernet Smart Switch will not accept a

file intended for the FS750/48 or FS750/24POE.

BPDU packets will now flood all ports when STP/RSTP feature is disabled.

The system VLAN configuration has been moved from the page, "IP Setup", to the page,

"Tagged VLAN".

The performance of TCP traffic has been improved compared to the previous version of

code. Large file transfers will now complete in the time that is appropriate for the networking

activity.

Operational Notes

When a 100FX SFP is inserted into the AT-GS950/48 Gigabit Ethernet Smart Switch it will

not be auto-detected and thus will initially not be operational. In order to make the SFP

module active, you must manually configure each individual SFP port as follows where the

100FX SFP is used:

1. From the main menu on the left hand side of the web management page, select Physical

Interface and the Physical Interface page is displayed

2. In the Port List, select one of the SFP ports (45 - 48) that you want to configure. The port

is highlighted in the port list.

3. In the Mode list, select "100FX-Full" for the port speed and duplex mode:

4. Click Modify. The Admin mode setting shown in the table for that port is changed. How-

ever, the SFP module configuration will not be activated and will not pass ethernet traffic

until the port configuration change is committed to the display and it is permanently

saved. See steps 6 and 7 below.

5. If you want to start the port re-configuration over, click Reload to clear the setting and go

back to step 2.

6. Click the OK button to commit the port configuration change to the display. Although it

may appear that the change is immediately activated, the change must first be perma-

nently saved before this occurs - see in step 7 below.

7. To permanently save these settings in the configuration file and activate the change,

select Save Configuration from the main menu on the left hand side of the web manage-

ment page and then click the Save button.

PN 613-000911 Rev B

AT-S87 Version 1.0.0 Software Release Notes

Allied Telesis, Inc.