Dell E178WFP - 17" LCD Monitor User Manual - Page 34

Browse online or download pdf User Manual for Monitor Dell E178WFP - 17" LCD Monitor. Dell E178WFP - 17" LCD Monitor 40 pages. Flat panel monitor
Also for Dell E178WFP - 17" LCD Monitor: Setup Manual (2 pages)

Print Page
Back to Contents Page
 

Product Specific Problems

Dell™ E178WFP Flat Panel Monitor User's Guide 
 Monitor Specific Troubleshooting
 Common Problems
 Product Specific Problems
CAUTION:
Before you begin any of the procedures in this section, follow the
 
Monitor Specific Troubleshooting
 Self-Test Feature Check (STFC)
Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly
connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:
1. Turn off both your computer and the monitor.
2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove the Analog (blue connector) cables from the back of
computer.
3. Turn on the monitor.
The floating 'Dell™ - Self-Test Feature Check' dialog box should appear on-screen (against a black background) if the monitor cannot sense a video
signal and is working correctly. While in self-test mode, the power LED remains green. Also, depending upon the selected input, one of the dialogs
shown below will continuously scroll through the screen.
4. This box also appears during normal system operation if the video cable becomes disconnected or damaged.
5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video controller and computer system; your monitor is functioning
properly.
OSD Warning Messages
For OSD-related issues, see
OSD Warning Messages

Common Problems

The following table contains general information about common monitor problems you might encounter.
COMMON SYMPTOMS
No Video/ Power LED off
No picture, monitor is dead
No Video/ Power LED on
No picture or no brightness
Poor Focus
Picture is fuzzy, blurry or ghosting
Shaky/Jittery Video
Wavy picture or fine movement
WHAT YOU EXPERIENCE
Safety
Instructions.
POSSIBLE SOLUTIONS
Check connection integrity at both ends of the video cable
l
Electric outlet verification
l
Ensure power button depressed fully
l
Increase brightness & contrast controls
l
Perform monitor self-test feature check
l
Check for bent or broken pins
l
Press Auto Adjust button
l
Adjust Phase and Clock controls through OSD
l
Eliminate video extension cables
l
Perform monitor reset
l
Lower video resolution or increase font size
l
Press Auto Adjust button
l