Allied Telesis SB251-10 Release Note - Page 13

Browse online or download pdf Release Note for Software Allied Telesis SB251-10. Allied Telesis SB251-10 14 pages. Patch for switchblade 4000 series switches and at-9800 series switches

Print Page
Allied Telesis SB251-10 Release Note
Patch SB251-10 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches
Patch SB251-10 for Software Release 2.5.1
C613-10361-00 REV J
PCR: 02587
Module: OSPF
When OSPF was enabled on startup, an OSPF interface would sometimes
stay in the DOWN state. This issue has been resolved.
PCR: 03001
Module: SWI CLASSIFIER
The following parameters have been changed CREATE CLASSIFIER, SET
CLASSIFIER and SHOW CLASSIFIER commands:
•
The MACTYPE parameter has been changed to
MACTYPE={L2UCAST|L2MCAST|L2BCAST|ANY}. This resolves
an error with internal hardware tables.
•
The number of user-specified protocols in the PROTOCOL parameter
has been increased from three to seven.
•
The minimum value of the IPXDADDRESS parameter has been
decreased from 10000000 to 00000001.
PCR: 03006
Module: SWI
An issue which sometimes resulted in a broadcast storm within the internal
ports on the SwitchBlade, a reduction in bandwidth, and a loss of pinging
has been resolved.
PCR: 3008
Module: SWI
An issue which caused pings to fail when a control card was inserted in the
left hand slot to act as a slave, has been resolved.
PCR: 03014
Module: IPG, SWI
Support has been added to allow for multicasting to any number of
overlapping VLANs up to the maximum number of multicast forwarding
entries.
PCR: 03018
Module: SWI
An issue with pings failing after network host routes disappeared from the
switch due to an IP hashing error has been resolved.
PCR: 03020
Module: SWI
An issue with an interrupt occurring when waiting on the MDIO which
caused the MDIO to read or write incorrect information has been resolved.
PCR: 03021
Module: SWI
Ping would sometimes not work correctly after a 48 line card was extracted,
and after a restart reboot. This issue has been resolved.
Availability
Patches can be downloaded from the Software Updates area of the Allied
Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html. A
licence or password is not required to use a patch.
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
13