Dell PowerVault MD3200 Series Installation Manual - Page 13

Browse online or download pdf Installation Manual for Storage Dell PowerVault MD3200 Series. Dell PowerVault MD3200 Series 18 pages. Storage arrays
Also for Dell PowerVault MD3200 Series: Update Manual (32 pages), Rack Installation Instructions (2 pages), Support Matrix (12 pages), Deployment Manual (38 pages), Information Update (1 pages), Support Matrix (17 pages), Technical Manualbook (40 pages), White Paper (22 pages), Deployment Manual (38 pages), Deployment Manual (38 pages)

Print Page

Managing SMI-S Provider

Starting and Stopping the OpenPegasus CIM

Server

To start or stop the OpenPegasus CIM server:

Open the Services window and locate the cimserver service. Right-click

•

cimserver service and select start or stop.

•

In the command prompt:

To start the service, type: net start cimserver

To stop the service, type: net stop cimserver

To start or stop the OpenPegasus CIM server, on a terminal window:

To start the service, type: cimserver

To stop the service, type: cimserver -s

Adding or Removing a Storage Array From SMI-S

Provider

At installation, you are prompted to enter the IP addresses into a file. After

this initial setup, the SMI-enabled client must use the SMI-S Provider proxy

server system management profile to add or remove devices.

NOTE:

When a storage array is added, an IP address of only one of the

management ports of the storage array must be supplied (and not both

management ports). Entering the IP addresses for both management ports of a

single storage array causes unpredictable behavior of the SMI-S Provider.

Managing SMI-S Provider