Dell PowerVault MD3620f Deployment Manual - Page 13
Browse online or download pdf Deployment Manual for Storage Dell PowerVault MD3620f. Dell PowerVault MD3620f 36 pages. Remote replication
Also for Dell PowerVault MD3620f: Configuration Manual (22 pages), Installation Manual (18 pages), Support Matrix (17 pages), Functional Manual (15 pages)
Print Page
Redundancy is established by installing separate data paths between the host
and the storage array, in which each path is to one of the two RAID controller
modules installed in the storage array. Redundancy protects the host from
losing access to data in the event of path failure, because both RAID
controller modules can access all the disks in the storage array.
For detailed information about all cabling configurations including direct and
SAN-attached hosts, cabling for remote replication environments, the use of
zoning, and HBA installation, see Configuring Fibre Channel With the Dell
MD3600f Series Storage Array, at support.dell.com/manuals.
Cabling PowerVault MD1200 Series Expansion
Enclosures
You can expand the capacity of your PowerVault MD3600f series storage array
by adding PowerVault MD1200 series expansion enclosures. You can expand
the physical disk pool to a maximum of 96 physical disks using a maximum of
seven expansion enclosures.
Expanding With Previously Configured PowerVault MD1200 Series
Expansion Enclosures
Use this procedure if your expansion enclosure is directly attached to and
configured on a Dell PERC H800 adapter. Data from virtual disks created on
a PERC H800 adapter cannot be directly migrated to a PowerVault MD3600f
series storage array or to a PowerVault MD1200 series expansion enclosure
connected to a PowerVault MD3600f series storage array.
CAUTION:
If a PowerVault MD1200 series enclosure that was previously attached
to PERC H800 adapter is used as an expansion enclosure to a PowerVault MD3600f
series storage array, the physical disks of the expansion enclosure are
reinitialized and data is lost. You must backup all data on the expansion enclosure
before attempting the expansion.
To attach previously configured PowerVault MD1200 series expansion
enclosures to the PowerVault MD3600f series storage array:
1 Back up all data on the expansion enclosure(s).
2 While the enclosure is still attached to the PERC H800 controller,
upgrade the expansion enclosure firmware to the latest version available
at support.dell.com.
Hardware Installation
13