Dell PowerVault MD3620f Deployment Manual - Page 31
Browse online or download pdf Deployment Manual for Storage Dell PowerVault MD3620f. Dell PowerVault MD3620f 36 pages. Remote replication
Also for Dell PowerVault MD3620f: Configuration Manual (22 pages), Installation Manual (18 pages), Support Matrix (17 pages), Functional Manual (15 pages)
Print Page
Working With SFP Modules and
Fiber Optic Cables
Each storage controller can have up to four FC host ports. A small-form-
factor pluggable (SFP) module is used to connect a host port to a host or
switch. The SFP module is inserted into the port, and then a fiber optic cable
is inserted into the SFP module. The other end of the fiber optic cable is
connected to an optical interface connector either in a FC HBA on a host or a
switch. SFP modules are laser products.
WARNING:
Data processing environments can contain equipment transmitting
on system links with laser modules that operate at greater than Class 1 power
levels. Never look into the end of an optical fiber cable or open receptacle.
Guidelines for Using SFP Modules
The storage array requires SFP modules. SFP modules convert electrical
signals to optical signals that are required for FC transmission to and from
RAID controller modules. After installing the SFP modules, fiber optic cables
are used to connect the storage array to other FC devices. Before installing
SFP modules and fiber optic cables, read the following information:
•
Use only Dell supported SFPs with the PowerVault MD3600f series storage
arrays. Other generic SFPs are not supported and may not work with the
storage arrays.
•
The SFP module housing has an integral guide key that is designed to
prevent you from inserting the SFP module incorrectly.
•
Use minimal pressure when inserting an SFP module into a FC port.
Forcing the SFP module into a port may damage the SFP module or
the port.
•
You can install or remove the SFP module while the port is powered on.
Working With SFP Modules and Fiber Optic Cables
B
31