Dell Storage Center SC220 Getting Started - Page 3
Browse online or download pdf Getting Started for Storage Dell Storage Center SC220. Dell Storage Center SC220 14 pages. Storage enclosures
Also for Dell Storage Center SC220: Service Manual (36 pages), Owner's Manual (27 pages)
Print Page
Installation and Configuration
WARNING:
instructions that came with all Storage Center components.
Unpacking the System
NOTE:
Unpacking, installing, and deploying your Storage Center may be
done only by a certified service technician.
Before you begin, make sure the site where you intend to set up and use
the Storage Center has the following:
•
Standard power from an independent source or a rack power
distribution unit with a UPS.
•
Storage Center with the latest firmware, BIOS, and drivers. Contact
your supplier for the correct software versions.
Installation Overview
The installation process follows the general steps below. For detailed
information, refer to vendor documentation supplied with the equipment.
CAUTION:
operating ambient temperature of the rack environment may be greater
than room ambient temperature. Therefore, consideration should be given
to installing the equipment in an environment compatible with the maximum
ambient temperature (Tma) specified by the manufacturer. For more
information, see "Technical Specifications" on page 8.
1 Assemble the rails following the safety instructions and the rack
installation instructions provided with your system.
2 Install network switches, as applicable.
3 Unpack the Storage Center controllers.
4 Unpack and install the IO cards into the Storage Center controllers.
5 Install the Storage Center controllers into the rack.
6 Unpack the enclosures.
7 Install the enclosures into the rack.
Before performing the following procedure, review the safety
If installed in a closed or multi-unit rack assembly, the
Getting Started With Your System
3