Dell C7008 Quick Start Manual - Page 22

Browse online or download pdf Quick Start Manual for Switch Dell C7008. Dell C7008 27 pages. Systems

Print Page

Access the System Remotely

You can configure the system to access it remotely by Telnet.

The systems have a dedicated management port and a management routing table

that is separate from the IP routing table.

Configuring the system for Telnet is a three-step process:

Step

Task

Configure an IP address for the management port.

Configure a management route with a default gateway.

Configure a username and password.

Configure the Management Port IP Address

Assign IP addresses to the management ports.

NOTE: Assign different IP addresses to each RPM's management port.

Step Task

Enter INTERFACE

mode for the

Management port.

Assign an IPv4 or

IPv6 address to the

interface.

Enable the interface.

Configure a Management Route

Define a path from the system to the network from which you are accessing the

system remotely. Management routes are separate from IP routes and are only

used to manage the system through the management port.

Command Syntax

interface ManagementEthernet

slot/port

ip address {ipv4-address | ipv6-

address}/mask

no shutdown

Command Mode

CONFIGURATION

INTERFACE

Installing the Software