3 Day Blinds HONEYCOMB SHADES UltraLift Cordless Getting Started - Page 2

Browse online or download pdf Getting Started for Window Blinds 3 Day Blinds HONEYCOMB SHADES UltraLift Cordless. 3 Day Blinds HONEYCOMB SHADES UltraLift Cordless 5 pages.

Print Page

OUTSIDE MOUNT

NOTE: You will be using your shade with mounting brackets

attached to the headrail to mark the position of the brackets

on your wall or molding. DO NOT CUT the cellophane

wrapping as the fabric or the cords supporting the shade

may be inadvertently cut.

• Attach brackets to the headrail 2" from each end. Additional

brackets, if included, are REQUIRED for proper installation

and should be spaced evenly over the width of the headrail.

Lower the shade to it's full length. (See "Shade Operation".)

NOTE: If using extension brackets, attach mounting brackets

to extension brackets with nuts and bolts before attaching

brackets to headrail. (See "Optional Accessories".)

2 | Honeycomb Shades UltraLift Cordless™

SIDE MOUNT

• Pull end cap out of head rail and slide the bracket

on as shown. Replace the end cap before sliding the

bracket all of the way into the head rail.

• Remove the endcap from the opposite end of the

headrail. Slide the remaining side mount bracket on

the headrail. Replace the end cap before sliding the

bracket all the way into the headrail.

• Hook one bracket onto the screw in the window

frame, using the keyhole slot. Bring the other end

bracket over the screw at the other side of the frame.

Slide down, flexing bracket inward until the screw

engages in the keyhole slot.

• Make sure both brackets are slipped down all the

way in the keyhole slot so that the screw is in the

top portion of the keyhole slot. Install a screw in the

bottom hole of each bracket. Tighten all screws.

• Line up the bracket top with

the desired height of the top

of the headrail.

• Mark holes for screws.

Brackets must be level.

Remove brackets and

drill holes.

• Insert bugle head screws

for keyhole slots only.

Approximately

" of

the screw should be

left protruding.

Rail