Dell Dell W- 620 Supplement Manual - Page 31

Browse online or download pdf Supplement Manual for Switch Dell Dell W- 620. Dell Dell W- 620 42 pages. Controllers with arubaos fips firmware non-proprietary security policy fips 140-2 level 2 release supplement

Print Page

This chapter covers the physical installation of the Aruba 620 and 650 Mobility Controllers with FIPS 140-2

Level 2 validation. The Crypto Officer is responsible for ensuring that the following procedures are used to

place the switch in a FIPS-approved mode of operation.

This chapter covers the following installation topics:

Precautions to be observed during installation



Requirements for the switch components and rack mounting gear



Selecting a proper environment for the switch



Mounting the switch in a rack



Connecting power to the switch



Pre-Installation Checklist

The following tools and equipment are required for installation of an Aruba 650 Series controller.

Rack Mount Bracket (x2, not used for tabletop installation)



6-32 x 1/4" Phillips Flat Head Screws (4x, included with rack mount brackets)



12-24 x 5/8" Phillips Flat Head Screws (4x, 19-inch (48.26 cm) rack system mount screws).



Suitable Screwdrivers for both screw types.



AC Power Cord (country-specific)



Left and right side bezels (not used for rack mounting)



To deploy an Aruba 650 Series controller on a flat surface, such as a tabletop, insert the four rubber

mounting feet to the bottom of the unit, attach side bezels by snapping them into place and then place the

unit on a hard flat surface.

The following tools and equipment are required for installation of an Aruba 620 controller.

Rack Mount Bracket (x2, not used for tabletop installation)



Screws (4x, included with rack mount brackets)



Suitable Screwdriver.



AC Power Cord (country-specific)



Left and right side bezels (not used for rack mounting)



To deploy an Aruba 620 controller on a flat surface, such as a tabletop, insert the four rubber mounting feet

to the bottom of the unit, attach side bezels by snapping them into place and then place the unit on a hard

flat surface.

Precautions

Installation should be performed only by a trained technician.



Dangerous voltage in excess of 240 VAC is always present while the Aruba Power Supply is plugged into



an electrical outlet. Remove all rings, jewelry, and other potentially conductive material before working

with this product.

Aruba 620, 650 and Dell W-620, W-650 | FIPS 140-2 Level 2 Release Supplement

Chapter 3

Installing the Controller

Installing the Controller |