Dell Force10 S50N Series Quick Start Manual - Page 20

Browse online or download pdf Quick Start Manual for Switch Dell Force10 S50N Series. Dell Force10 S50N Series 25 pages. Rapid equallogic configuration series configuration introduction array: ps4100 host: vmware esxi
Also for Dell Force10 S50N Series: Implementation Manual (9 pages)

Print Page

Assign Interfaces to a VLAN

A port may either be an untagged member of a single VLAN, or a tagged

member of perhaps multiple VLANs.

•

Untagged Ports — ports that do not append an 802.1Q VLAN tag to frames

on egress, and do not accept tagged frames on ingress (tagged frames are

dropped). Untagged ports must be connected to VLAN-unaware devices.

•

Tagged Ports — ports that append an 802.1Q tag to frames on egress, and

accept only tagged frames on ingress (untagged frames are dropped). Tagged

ports must be connected to VLAN-aware devices.

When you configure an enabled port as a switchport, the port is placed in the

default VLAN. To remove a switchport from the default VLAN, remove the

switchport configuration. To move the port to another VLAN, add it to the

desired VLAN as either a tagged or untagged member.

To view just the interfaces that are in Layer 2 mode, enter the show interfaces

switchport command in the EXEC mode.

Step Task

Assign a switchport to

a VLAN.

Display all

switchports and the

VLANs of which they

are members.

Assign an IP address to a VLAN

NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,

is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default

vlan-id vlan-id command.

Task

Configure an IP address and mask on

the interface.

Installing the Software

Command Syntax

[tagged | untagged] interface

show vlan

Command Syntax

ip address ip-address

mask [secondary]

Command Mode

INTERFACE VLAN

EXEC Privilege

Command Mode

INTERFACE