Dell Force10 S55 Quick Start Manual - Page 25

Browse online or download pdf Quick Start Manual for Switch Dell Force10 S55. Dell Force10 S55 29 pages.
Also for Dell Force10 S55: Manual (50 pages)

Print Page

Create a Port-based VLAN

The Default VLAN as VLAN 1 is part of the system startup configuration and

does not require configuration. To configure a port-based VLAN, you must

create the VLAN and then add physical interfaces or port channel (LAG)

interfaces to the VLAN.

Task

Configure a port-based VLAN (if the

vlan-id is different from the Default

VLAN ID) and enter INTERFACE

VLAN mode.

NOTE: After you create a VLAN, you must assign interfaces in Layer 2 mode to

the VLAN to activate the VLAN.

Use the show vlan command in the EXEC privilege mode to view the

configured VLANs.

Assign Interfaces to a VLAN

To view just the interfaces that are in Layer 2 mode, enter the show interfaces

switchport command in the EXEC privilege mode or EXEC mode.

To tag frames leaving an interface in Layer 2 mode, you must assign that

interface to a port-based VLAN to tag it with that VLAN ID. To tag interfaces,

use these commands in the following sequence:

Step Task

Access the

INTERFACE VLAN

mode of the VLAN to

which you want to

assign the interface.

Enable an interface to

include the IEEE

802.1Q tag header.

Command Syntax

interface vlan vlan-id

Command Syntax

interface vlan vlan-id

tagged interface

Command Mode

CONFIGURATION

Command Mode

CONFIGURATION

INTERFACE

Installing the Software