Dell Force10 S55 Manual - Page 39

Browse online or download pdf Manual for Switch Dell Force10 S55. Dell Force10 S55 50 pages.
Also for Dell Force10 S55: Quick Start Manual (29 pages)

Print Page

• In order to comply with the GR-1089 Lightning Criteria for Equipment Interfacing with AC Power

Ports, an External Surge Protective Device (SPD) is intended to be used at the AC input of the router.

WARNING: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear an

ESD-preventive wrist or heel ground strap when handling the S55 and its components.

CAUTION: The intra-building port(s) of the equipment or sub-assembly is suitable for connection to intra-

building or unexposed wiring or cabling only. The intra-building port(s) of the equipment or sub-assembly

MUST NOT be metallically connected to interfaces that connect to the OSP or its wiring. These interfaces are

designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE,

Issue 5) and require isolation from the exposed OSP cabling. The addition of Primary Protectors is not

sufficient protection in order to connect these interfaces metallically to OSP wiring.

Figure 8-1. USA Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant

to Part 15 of the FCC rules. These limits are designated to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the

instructions, it may cause harmful interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference, in which case users will be required to take

whatever measures necessary to correct the interference at their own expense.

Properly shielded and grounded cables and connectors must be used in order to meet FCC emission

limits. Dell Force10 is not responsible for any radio or television interference caused by using other than

recommended cables and connectors or by unauthorized changes or modifications in the equipment.

Unauthorized changes or modification could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Figure 8-2. Canadian Department of Communication Statement

Figure 8-3. European Union EMC Directive Conformance Statement

This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on

the approximation of the laws of the Member States relating to electromagnetic compatibility. Dell

Force10 can not accept responsibility for any failure to satisfy the protection requirements resulting from

a non-recommended modification of this product, including the fitting of non-Dell Force10 option cards.

This product has been tested and found to comply with the limits for Class A Information Technology

Equipment according to CISPR 22/European Standard EN 55022. The limits for Class A equipment were

derived for commercial and industrial environments to provide reasonable protection against interference

with licensed communication equipment.

S55 Specifications