Dell N2000 Series Manual - Page 8
Browse online or download pdf Manual for Switch Dell N2000 Series. Dell N2000 Series 17 pages. Switch dell networking n2000 series
Also for Dell N2000 Series: Firmware Upgrade (21 pages)
Print Page
2.3
Configure out-of-band management port (Optional)
This section will configure a 1GbE port to be used as a dedicated out-of-band (OOB) management port. It
is recommended to perform this step. If you skip this step, then all configuration and monitoring must be
performed via the serial ports.
Note: In the configuration below, Vlan 50 is used for management. Use any valid non-default vlan in your
setup. The IP address provided should be accessible from your management system (and not connected
to the SAN). The switch port used in this configuration should be connected to a LAN or management
network.
console>enable
console#configure
console(config)#vlan 50
console(config-vlan50)#exit
console(config)#interface vlan 50
console(config-if-vlan50)#ip address ipaddress mask
console(config-if-vlan50)#exit
console(config)#interface gigabitethernet 1/0/port number
console(config-if-Gi1/0/port number)#switchport access vlan 50
console(config-if-Gi1/0/port number)#exit
Note: If your management system is in the same subnet as the switch, omit the step below.
console(config)#ip default-gateway gateway
Warning! Notice! The configured default gateway will not take effect until an
interface belonging to the same subnet as the configured Gateway is created and
activated.
console(config)#exit
2.4
HTTP and Telnet authentication
console#configure
console(config)#line telnet
console(config-telnet)#login authentication default
8
SCG1015
Dell Networking N2000 Series Configuration Guide