Dell N4000 Series Configuration Manual - Page 16

Browse online or download pdf Configuration Manual for Switch Dell N4000 Series. Dell N4000 Series 17 pages. Expansion modules for dell networking switches
Also for Dell N4000 Series: Reference Manual (17 pages)

Print Page

4.2

Revert to default VLAN ID on switch and arrays

Once DCB is disabled on the switch, the EqualLogic arrays will no longer use the VLAN ID that was

configured when DCB was enabled. The arrays will revert to the default or native VLAN. Therefore, a valid

VLAN must be configured for all host servers, switches, and EqualLogic array members. A valid VLAN can

use the default or native VLAN ID (typically 0 or 1) or a specific VLAN can be configured (for example,

VLAN 100). If a non-default VLAN is configured, then any ports connected to the arrays must be

configured as "untagged".

Use the steps below to configure the native VLAN on the switch.

console#configure

console(config)#interface range tengigabitethernet all

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#interface range fortygigabitethernet all

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#interface port-channel 1

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#no vlan vlan-id

console(config)#exit

4.3

Save configuration

console# copy running-config startup-config

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to save? (y/n)y

4.4

Configure additional switch

Repeat the commands from Section 4 to disable DCB on any additional switches.

SCG1001

Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide