Dell PowerConnect 2024 User Manual - Page 16

Browse online or download pdf User Manual for Switch Dell PowerConnect 2024. Dell PowerConnect 2024 46 pages. Unmanaged switches
Also for Dell PowerConnect 2024: System Information Manual (33 pages)

Print Page

FILE LOCATION: C:\A-2003 Working Folder\All PowerConnect\E-Doc Posts\Eng UG rev\7H905ch.fm

NOTE: For racks that

are not pre-threaded,

cage nuts are provided.

D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 6 / 3 / 0 3

Ov er v ie w

Installing on a Flat Surface

The switch can be installed on any appropriate level surface that can safely

support the weight of the hubs and their attached cables. There must be

adequate space around the switch for ventilation and access cable

connectors.

To install the switch on a flat surface, complete the following steps:

Set the switch on the flat surface and check for proper ventilation.

Allow at least 2 inches (5.1 cm) on each side for proper ventilation and

5 inches (12.7 cm) at the back for power cord clearance.

Attach rubber feet on each marked location on the bottom of the

chassis.

The rubber feet are optional but recommended to keep the unit from

slipping.

Installing in a Rack

The switch can be installed in most standard 19-inch racks.

To install the switch in a rack, complete the following steps:

Use the supplied screws to attach a mounting bracket to each side of

the switch.

Position the switch in the rack and align the holes in the mounting

bracket with the holes in the rack.

Insert and tighten two screws appropriate for your rack through each of

the mounting brackets.