Dell PowerConnect 5212 Documentation Update - Page 10

Browse online or download pdf Documentation Update for Switch Dell PowerConnect 5212. Dell PowerConnect 5212 18 pages. Addendum to the user's guide

Print Page
Y1836bk0.book Page 8 Tuesday, July 15, 2003 12:55 PM
Table 1-1. 802.1x Port Configuration CLI Commands (continued)
Command
dot1x max-req count
dot1x re-
authentication
dot1x timeout quiet-
period seconds
dot1x timeout re-
authperiod seconds
dot1x timeout tx-
period seconds
show dot1x
[statistics]
[interface
interface ]
The following is an example of the 802.1x CLI commands:
Console(config)#authentication dot1x default radius
Console(config)#interface ethernet 1/1
Console(config-if)#dot1x port-control auto
Console(config-if)#dot1x max-req 5
Console(config-if)#dot1x re-authentication
Console(config-if)#dot1x timeout quiet-period 40
Console(config-if)#dot1x timeout re-auth 5
Console(config-if)#dot1x timeout tx-period 40
Console(config-if)#exit
Console(config)#exit
Console#dot1x re-authenticate
Console#show dot1x
8
Documentation Update
Usage
Sets the maximum number of times the switch port
will retransmit an EAP request packet to the client
before it times out the authentication session. Use the
no form to restore the default.
Enables periodic reauthentication for the port. Use the
no form to disable reauthentication.
Sets the time that a switch port waits after the max
request count has been exceeded before attempting to
acquire a new client. Use the no form of this
command to reset the default.
Sets the time period after which a connected client
must be reauthenticated. Use the no form to restore
the default.
Sets the time that the switch waits during an
authentication session before retransmitting an EAP
packet. Use the no form to reset to the default value.
Use this command to show general port
authentication related settings on the switch or a
specific interface.