Dell PowerConnect 6224 Release Note - Page 29

Browse online or download pdf Release Note for Switch Dell PowerConnect 6224. Dell PowerConnect 6224 34 pages. Powerconnect 6200 series
Also for Dell PowerConnect 6224: Specifications (2 pages), Planning And Preparation Manual (12 pages)

Print Page

PowerConnect 6224/6224F/6224P/6248/6248P Release Notes

Summary

User Impact

ISDP updates are not

Upon changing configuration immediately

including Voice VLAN

after getting the VLAN assigned, DUT stops

Reply TLV when

advertising Voice VLAN reply TLV in its

Voice VLAN ID on

ISDP updates which causes IP phone to

interface is changed.

change its VLAN properties.

PC6200 fails to re-

Once a phone is configured, enable Voice

authorize IP phone

VLAN authentication, wait for DHCP

upon enabling and

discovery again, and then disable Voice

disabling Voice VLAN

VLAN authorization. On disabling Voice

authentication.

VLAN authorization, PC6200 fails to

authorize IP phone based on the received

LLDP packet (with network policy TLV).

When Line or enable

If login authentication method is Line or

method is used as

Enable, and enable authentication is None,

you will always get read-only access

enable authentication

(because there is no user configured for line

is none, the user is

or enable authentication). The user will

unable to enter into

never get read-write access.

Privileged EXEC

mode.

Cannot change LAG

Cannot change LAG mode from Static to

mode from Static to

Dynamic via CLI.

System Firmware Version 3.2.0.6

Workaround

The administrator can work around this

problem by shutting down the port and

restarting it after the configuration is

changed.

Disconnect and reconnect the phone to the

port, the phone gets authorized.

If enable authorization is set to None, ensure

that the login authorization method is at least

TACACS, Radius, or Local. Any

authentication method that requires a user

configuration will ensure that the user will get

proper access based on how the user is

configured.

The user may change the LACP Mode using

the Graphical User Interface.

Page 27