Dell PowerConnect BI-RX-16 Getting Started Manual - Page 30

Browse online or download pdf Getting Started Manual for Switch Dell PowerConnect BI-RX-16. Dell PowerConnect BI-RX-16 32 pages. Powerconnect b-rx series

Print Page

Dell PowerConnect BI-RX-16 Getting Started Manual

2. Enter the following command at the Privileged EXEC level prompt (for example, BigIron RX#), then press Enter.

This command erases the factory test configuration if still present:

BigIron RX# erase startup-config

CAUTION

Use the erase startup-config command only for new systems. If you enter this command on a system you

have already configured, the command erases the configuration. If you accidentally erase the

configuration on a configured system, enter the write memory command to save the running

configuration to the startup-config file.

3. Access the configuration level of the CLI by entering the following command:

BigIron RX# configure terminal

BigIron RX(config)#

4. Configure the IP address and mask for the management interface by entering the following commands:

BigIron RX(config)# interface management 1

BigIron RX(config-if-mgmt-1)# ip address 10.0.1.1 255.255.255.0

Assigning an IP address to an interface, virtual Interface, or loopback

You must assign an IP address to each interface and virtual interface over which user packets are routed. You can

also assign an IP address to a loopback interface, which is generally used for testing and diagnostic purposes.

You must use the serial connection to assign the first IP address. For subsequent addresses, you also can use the

CLI through Telnet or the Web management interface. You can use the switch's Network Manager to assign IP

addresses to virtual routing interfaces only.

By default, you can configure up to 24 IP interfaces on each interface, virtual interface, and loopback interface.

For example, to assign the IP address 192.22.3.44 and sub-net mask 255.255.255.0 to Ethernet interface 1/1, do

the following.

1. At the opening CLI prompt, enter enable.

BigIron RX> enable

2. Enter the following command at the Privileged EXEC level prompt, then press Enter. This command erases the

factory test configuration if still present: