3 Day Blinds VINYL BLINDS Getting Started - Page 9

Browse online or download pdf Getting Started for Window Blinds 3 Day Blinds VINYL BLINDS. 3 Day Blinds VINYL BLINDS 10 pages.

Print Page

TILT WAND ATTACHMENT

(Not applicable for blinds ordered with a cord tilt)

| Vinyl Blinds

• At the top of the tilt wand

(provided separately),

you will find a plastic

sleeve that covers a metal

hook.

• Remove the plastic sleeve

on the tilt wand by pulling

gently upward.

• Make sure the metal hook

attached to the tilt wand

is in the open position.

• On one end of the

headrail, you will find a

small metal shaft with a

hole protruding from the

headrail.

• Take the plastic sleeve

you just removed from

the tilt wand and slide

it up and over the shaft

protruding from the

headrail so that the hole

at the end of the shaft is

exposed.

• Insert the metal hook into

the hole in the shaft.

• Slide the plastic sleeve

down the shaft and over

the tilt wand hook until it

is secure.

BLIND OPERATION

• To tilt the slats, twist the tilt wand. If you ordered a cord

tilt, YOU MUST take one cord in each hand applying slight

tension to each cord, and pull gently down to tilt the slats to

the desired angle.

• Do not attempt to raise or lower the blind unless the slats

are in a completely open (horizontal) position.

• To raise the blind, pull the lift cords down.

• To engage the lock, pull the lift cords down and toward the

outside of the blind.

• To lower the blind, pull the lift cords down and toward

the center of the blind and allow the cords to slide slowly

through your hand.