AVX AVX-SAT4 Owner's Manual - Page 3

Browse online or download pdf Owner's Manual for Speakers AVX AVX-SAT4. AVX AVX-SAT4 6 pages. 70v / 100v / 8 ohm outdoor landscape speakers

Print Page

WARNING

Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage

to the device or other property. These precautions include, but are not limited to, the following:

Location

Before moving the device, remove all connected cables.

Avoid setting all equalizer controls and faders to their maximum.

Depending on the condition of the connected devices, doing so may cause

feedback and may damage the speakers.

Do not expose the device to excessive dust or vibrations, or extreme cold

or heat. To prevent the possibility of panel disfiguration or damage to the

internal components.

Do not place the device in an unstable position where it might accidentally

fall over or be subjected to damage.

IMPORTANT

Please record the serial number of this unit in the space below.

Model:

Serial No.:

The serial number is located on the bottom or rear of the unit.

Retain this Owner's Manual in a safe place for future

reference.

Connections

•Before connecting the device to other devices, turn off the power for

all devices. Before turning the power on or off for all devices, set all

volume levels to minimum.

Handling Precautions

Do not use the device for a long period of time at a high or

uncomfortable volume level, since this can cause damage to the

speakers.

Protective Circuit (poly switch)

All full-range loudspeakers are fitted with a self-resetting poly switch

that protects the high-frequency driver from damage caused by

excessive power. If a loudspeaker cabinet loses high-frequency output,

immediately remove power from the unit and wait for two to three

minutes. This should be long enough to allow the poly switch to reset.

Reapply power and check the performance of the high frequency

driver before continuing, with the power reduced to a level that does

not cause the poly switch to interrupt the signal.

Interference From Cell Phone

The manufacturer will not be responsible for damage

caused by improper use or modification to the device.