Dell PowerEdge M420 User Manual - Page 12

Browse online or download pdf User Manual for Switch Dell PowerEdge M420. Dell PowerEdge M420 26 pages. Dell poweredge blade servers getting started guide
Also for Dell PowerEdge M420: Information Update (38 pages), Release Notes (27 pages), Manual (25 pages), User Manual (23 pages), Important Information Manual (35 pages), Update Manual (32 pages), Update Manual (28 pages), User Manual (22 pages), Getting Started Manual (12 pages), Manual (38 pages), Technical Manual (46 pages), Technical Manual (48 pages), Portfolio Manual (27 pages), Getting Started Manual (14 pages), Getting Started Manual (12 pages)

Print Page

Rev 1.00

Command Line Interface (CLI) Reference

10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described

in this section after successfully connecting to the 10GbE PTM CLI according to the procedure

described in

Section 2, "Connecting to the 10GbE PTM CLI," on page

3.1

CLI Privilege Levels

The 10GbE PTM supports the following user privilege levels:

• USER - Common user level, indicated by the # prompt

• ADMIN - Administrator level, indicated by the & prompt

Different commands are available in different privilege levels. The command reference indicates

the required privilege level for each command that requires a privilege level higher than USER.

3.2

Quick Reference

Table 5 provides a quick reference to the CLI commands:

Command name

General Commands

help

exit

Software Image Commands

show image ver

copy image from-file

Device Commands

show device temp

Port Commands

show port link

Table 5 - List of Commands

Short Description

Shows the list of available commands

Exit from the 10GbE PTM CLI

Change privilege level

Shows the software image version

Upload new software image to the 10GbE PTM

Shows the temperature of a specified device

Shows port link state

Reference

Section 3.4.1, "help," on page 13

Section 3.4.2, "exit," on page 14

Section 3.4.3, "login (ADMIN)," on

page 14

Section 3.5.1, "show image ver," on

page 14

Section 3.5.2, "copy image from-file,"

on page 15

Section 3.6.1, "show device temp

(ADMIN)," on page 15

Section 3.7.1, "show port link," on

page 16

Software User's Manual